|
|
|
|
Reflections Without the rear glass in it was hard to believe those lights would fit, not sure I would have got the holes drilled had the glass been in the car. |
 | |  |
|
Woodwork
Before I put the flooring it I want get everything I can done to minimize having to walk on the mats. An original package tray was painted but before it was installed I wanted to blank off the unused speaker openings. With the pieces of wood cut some insulation was placed on the package tray and over the seat back board, the original package trays had insulation on them. Once the panel was secured I used a tiny drill from in the trunk to drill a pilot hole in the panel. I was able to get the drill in three of the four holes, the holes were opened up from on top and using a bracket I was able to locate the fourth hole. While i was working with wood I cut the plywood for the radio. The holes were located through the trunk floor by running the screws in from the bottom and pressing the board on them to mark them. I don't like the white showing through the package tray, I think the factory panel had primer on it. I'll brush it out later. I did get the deck lights installed. | |
 | |  |
| | |
|
| |
| | |
