|
|
|
|
Reflections A couple things, I checked it a little while later and noticed it slipped back. I then chose to swap out the transmission mount to a two piece polyurethane type that had integrated spacers on each side. With those installed I figured it would all settle in once it the engine was run. |
 | |  |
|
Shifted
When I had the exhaust installed they noticed that the engine was askew so I felt now was a good time to address that. My first thought was to unbolt the engine mounts and push the transmission over, I figured if I lifted the engine I should be able to move the tailshaft, not so. With the engine lifted I used some ratchet straps and pulled the assemble square and lowered the hoist, it took multiple attempts before I could get it to settle in the needed position. | |
 | |  |
| | |
|
| |
| | |
