December

December 20, 2015

The CHP use this tubing to run wire through, three different sizes were acquired and the correct size clamps. The clams were installed in the original holes drilled by the CHP. The CHP used sheet metal screws in most locations but the far clamp couldn't be put in with a sheet metal screw so a machine screw was used. This screw is seen in a vintage photo and a on the salvage harness we were lucky enough to find, oh, I had to track down a slotted round head screw, thank god for McMaster Carr.

More Pictures

◄PreviousIndexNext►

Highslide JS

Highslide JS

   

◄PreviousIndexNext►